Free Shipping on All Orders Over $75!   



1972 BMW R75/5 - Rear Drive Shaft Boot Shavings?

Good morning to you all, Yesterday I cleaned up the rear swing arm area and removed the transmission drive shaft transition boot, turned it inside out and discovered the following fillings. Where would have this come from...


1972 BMW R75/5 - Swing Arm Bearings

Good day to you all! Cleaned my swing arm yesterday with emphasis on the swing arm bearing area. The question came to mind, do they need replacing and how can one tell if the do From what I remember on the R75/6 project, you have to remove the outer seals to inspect and make a decision from......


Kacoma straight (No. 2) petcock disassembly

Attempting to rebuild my petcocks, but I can?t get the threaded washer off. I tried beating it in a circle with a screw driver and mallet and that worked for a while. I also tried with a spanner that I use for photography lens repair, but it just slips. Clymer doesn?t say anything about a......


Bearing Reference List for R75/5

Good day to you all, I remember seeing a list of replacements for bearings for the R75/5/6 somewhere and my poor old brain aint what it used to be. Would anyone have idea where one would look...


steering head bearings /5 replace

What parts will be needed to replace the steering head bearings on a 75/5 Are they any old bearings or do you have to use the BMW ones...


Clutch cable replacement

I installed a new pair of clutch cables in the 76 R90S this afternoon. The process went reasonably smoothly until I attempted to mount the adjustment mechanism to the engine case. The center bolt did not attach to the engine case. When I disassembled the choke unit and attempted to insert just......


Goggles News:

1972 BMW R75/5 - Rear Drive Shaft Boot Shavings?

Good morning to you all, Yesterday I cleaned up the rear swing arm area and removed the transmission drive shaft transition boot, turned it inside out and discovered the following fillings. Where would have this come from...


1972 BMW R75/5 - Swing Arm Bearings

Good day to you all! Cleaned my swing arm yesterday with emphasis on the swing arm bearing area. The question came to mind, do they need replacing and how can one tell if the do From what I remember on the R75/6 project, you have to remove the outer seals to inspect and make a decision from......


Kacoma straight (No. 2) petcock disassembly

Attempting to rebuild my petcocks, but I can?t get the threaded washer off. I tried beating it in a circle with a screw driver and mallet and that worked for a while. I also tried with a spanner that I use for photography lens repair, but it just slips. Clymer doesn?t say anything about a......


Bearing Reference List for R75/5

Good day to you all, I remember seeing a list of replacements for bearings for the R75/5/6 somewhere and my poor old brain aint what it used to be. Would anyone have idea where one would look...


steering head bearings /5 replace

What parts will be needed to replace the steering head bearings on a 75/5 Are they any old bearings or do you have to use the BMW ones...


Clutch cable replacement

I installed a new pair of clutch cables in the 76 R90S this afternoon. The process went reasonably smoothly until I attempted to mount the adjustment mechanism to the engine case. The center bolt did not attach to the engine case. When I disassembled the choke unit and attempted to insert just......


Search results for "Goggles - VonZipper"

Next Page