Are Krauser Bags transferable between a /5 and a /6. In other words can I use one set of bags on both bikes...
Good evening to everyone,
All my restoration projects have involved powder coating the black parts with good success. I recently rebuilt an open cargo trailer and tried POR 15 gloss black car frame paint and was amazed to the toughness, which led me to think, ?would this work on a BMW R series......
Good evening,
I will be stripping the 32mm Bing carbs shortly and have purchased an Ultrasonic cleaner big enough to accommodate the entire body.
What solution works well under these circumstances. With the right solution, is heating the solution necessary or needed.
Read so many comments,......
I know cold oil and high RPMs can collapse the filter. I thought it crunched the filter paper not bend metal....
Good morning to you all,
Yesterday I cleaned up the rear swing arm area and removed the transmission drive shaft transition boot, turned it inside out and discovered the following fillings. Where would have this come from...
Good day to you all!
Cleaned my swing arm yesterday with emphasis on the swing arm bearing area. The question came to mind, do they need replacing and how can one tell if the do From what I remember on the R75/6 project, you have to remove the outer seals to inspect and make a decision from......
Goggles News:
Are Krauser Bags transferable between a /5 and a /6. In other words can I use one set of bags on both bikes...
Good evening to everyone,
All my restoration projects have involved powder coating the black parts with good success. I recently rebuilt an open cargo trailer and tried POR 15 gloss black car frame paint and was amazed to the toughness, which led me to think, ?would this work on a BMW R series......
Good evening,
I will be stripping the 32mm Bing carbs shortly and have purchased an Ultrasonic cleaner big enough to accommodate the entire body.
What solution works well under these circumstances. With the right solution, is heating the solution necessary or needed.
Read so many comments,......
I know cold oil and high RPMs can collapse the filter. I thought it crunched the filter paper not bend metal....
Good morning to you all,
Yesterday I cleaned up the rear swing arm area and removed the transmission drive shaft transition boot, turned it inside out and discovered the following fillings. Where would have this come from...
Good day to you all!
Cleaned my swing arm yesterday with emphasis on the swing arm bearing area. The question came to mind, do they need replacing and how can one tell if the do From what I remember on the R75/6 project, you have to remove the outer seals to inspect and make a decision from......